Product features
This system can be applied to both water-cooled and oil-cooled gun lines for heat dissipation. It can operate normally at a temperature of 50 degrees Celsius and with a thermal power consumption of 2.5KW.
2. The product is small in size and light in weight, with strong scalability. It can be assembled in any desired manner according to the customer's structure.
3. The maximum system flow rate can reach 5 liters per minute (when the pressure is less than 6 Bar). It is suitable for use with the 600A single gun, and can also be used in a dual-gun configuration with 600A (the total power during operation of both guns does not exceed 600A).
4. Equipped with a precise control system, it uses the PWM duty cycle method to precisely adjust the speed of the water pump and the fan, in order to meet the operation requirements under different working conditions.
5. Closed-loop feedback system can provide real-time feedback on the total system pressure, system inlet temperature, system outlet temperature, low liquid level alarm, pump failure alarm, and fan speed signal during system operation.
6. IP55 water and dust protection function + WF1 outdoor anti-corrosion grade
2.5KW standard type gunline terminal cold source
|
Product Name
|
Quantity
|
Parameters
|
Note
|
|
Turbo pump
|
1
|
60W centrifugal pump (maximum flow rate 0.04 liters/second, maximum pressure 4.5 Bar), glycol medium.
|
DC 24V PWM speed control
|
|
Tricarbon ethylene propylene diene monomer rubber
|
N/A
|
D8 inner diameter polyether propylene rubber hose
|
Special for water ethylene/glycol solution
|
|
Sensor
|
2
|
1. Integrated temperature and pressure sensor (PT1000 temperature sensor + 1MPa pressure transducer).
2. Temperature sensor (PT1000 temperature sensor)
|
|
|
2.5KW heat exchanger + fan assembly
|
2
|
Heat exchanger: Width (W) 120mm, Height (H) 275mm, Depth (D) 32mm. Fan assembly: 2 PCS DC brushless fans (single fan 120*120*38/ thick)
|
Single heat exchanger: Theoretical cooling power 1.5KW
|
|
Liquid storage tank
|
1
|
PP material injection molding + hot plate welding process (with built-in liquid level sensor and an additional 1.2Bar water tank-specific expansion cap), equipped with liquid level alarm sensor
|
The maximum capacity of the water bottle is 0.8 liters and it can withstand a pressure of 6Bar (less than 10 minutes)
|
